It should be installed in the discharge air duct at a point where the air and gas have had sufficient distance to mix

verify your wiring integrity and check for induced transient voltages from nearby high-voltage lines

For contractors performing a furnace blower motor replacement on 277V equipment

Featuring a 37 Cv rating and female NPT threaded connections

York 025-28678-102 Pressure Transducer Refrigerant It should be installed inThe York 025 28678 102 Evaporator Pressure Transducer is a precision engineered HVAC OEM alternative for critical pressure monitoring in commercial chiller systems. As an essential refrigerant pressure sensor, this unit converts evaporator side pressure into a stable 0 5 VDC linear signal, allowing your unit controller to maintain optimal superheat and prevent coil freeze up. Built for the rigors of mechanical rooms, this 025 28678 102 transducer