This regulator must be installed in the suction line as close to the compressor as possible to accurately sense and limit the inlet pressure

Operating on a 240V single-phase circuit

These fittings permit a "drop-in" retrofit for older valve footprints

A diagnostic multimeter test showing an open circuit across the RE0240900 terminals during induction usually confirms the diaphragm has failed or the set point is no longer being reached

Tekmar Controls 156 Control R-448A This regulator must be installedThe Tekmar Controls 156 is a versatile Difference Setpoint Control designed for high efficiency heat transfer between a primary source and a storage tank. Operating on a 24Vac dc power supply, this microprocessor based controller utilizes two 10k sensors to monitor real time temperature differentials (? T). When the source temperature exceeds the storage temperature by the user defined setpoint, the internal 240V, 10A relay closes to activate an on