set it on the table and try and lift it with a large screwdriver

and on—and simple wiring setup

This modern unit replaces the often problematic Lucas rectifier and Zener diode found on vintage Triumph

and include the pinch bolt and washer

Handlebar Shims Reduce 1 inch risers for 7/8 handlebars Triumph #97-1425 Subcategory_Ignition Systems set it on the tableThese handlebar shims, or reducers, allow you to run 7 8" bars in 1" risers or stock Triumph motorcycle p clamps. Simply place them in your risers with your bars, tighten down and you are good to go. These pieces are how the stock Triumph p clamps with a 1" inside diameter took the factory 7 8" handlebars. Factory shims, seems a bit strange but that is how it was done! These will work with any 1" riser 7 8" handlebar combo, allowing you to run some